Geradores diesel industriais de 431PSL6208 180KW 225KVA

MP 430 Frame Generators

1.OUTSTANDING ELECTRIC CHARACTERISTICS

• STEADY VOLTAGE REGULATION IS LESS THAN 1%.
• TRANSIENT VOLTAGE REGULATION IS LESS THAN + 20%,-15%(60%IN,P.FW0.4LAG).
• VOLTAGE ADJUSTING RANGE IS OVER THAN 5% OF UN.
• TOTAL VOLTAGE WAVEFORM DISTORTION IS LESS THAN 5%(L-L)
• THERMAL WARP: APPROXIMATELYZERO.

2.UNIQUE STRUCTURE

• FULL GUARDED FOR OPERATOR SAFETY. THE UNITS HAVE A UNIQUE VENTILATION AND STRUCTURE ,AND EFFICIENT HEAT TRANSFER AND COOLING.
• BRUSHLESS EXCITATION WITH SOLID - STATE CIRCUIT AVR,( SE350 ) WHICH IS ENCAPSULATION FOR MOISTURE AND VIBRATION PROTECTION.
• UN I ROTOR CONSTRUCTION WITH FULL DAMPING WINDING (DIE CAST),FIELD WINDINGS ARE LAYER WOUND WITH THERMO-SETTING EPOXY FOR MECHANICAL AND ELECTRICAL INTEGRITY.
• STATOR WINDING OF 2/3 PITCH, MINIMIZE HARMONIC DISTORTION.
• H CLASS INSULATION SYSTEM.
• DOUBLE SHIELDED & PRE- LUBRICATED BEARING FOR HIGH LIFE (B10,N 20000 HOURS).
• RECTIFIER ASSY. LOCATED OUTBOARD OF THE EXCITER FOR EASY SERVICE.
• CONDUIT BOX IS MOUNTED ON THETOP OF FRAME. THE ACCESSORIES CAN BE INSTALLED IN THE AMPLE BOX.
• PARALLELING MODULE & ACCESSARIES CAN BE ASSEMBLED AS CUSTOMER REQUESTED.
• PMG & DVR2000E CAN BE ASSEMBLED AS CUSTOMER REQUESTED.
• HEATER AND THERMAL PROTECTION ELEMENT CAN BE ASSEMBLED AS CUSTOMER REQUESTED.
• LEADS AND 8 POLES LINKBOARD. 12 LEADS AS OPTION.
• STANDARD SAE ADAPTION.

AMBIENT TEMPERATURE ^40°C

ALTITUDES 1000M.

NOTE: IFTHE ENVIRONMENT CONDITION IS HIGHER OR DIFFERENT FROM ABOVE REQUIREMENTS, THE OUTPUT POWER SHOULD REFER TO CORRESPONDING DECREATED TABLE.

4. VOLTAGE_fFREQUENCY_fREV_f POWER FACTOR,OPERATION

RATED VOLTAGE :400V(50HZ) OR 480V(60HZ)

RATED FREQUENCY:50HZ OR 60HZ

RATED REV:1500 RPM OR1800RPM

POWER FACTOR :0.8 LAG

OPERATION: CONTINUOUS(SI)

ACCORDING TO CUSTOMERS* REQUIREMENTS ,WE CAN OFFER DIFFERENT KINDS OF OUTPUT VOLTAGE. ALSO WE CAN OFFER SPECIAL DESIGNS.

5. RESISTANTTO ELECTROMAGNETISM

GENERATOR EQUIPPED WITH SE350 AVR ACCORDS WITH NORMAL LEVEL.

6. BEARING

SHIELDED HEAVY-DUTY BEARING RESISTS CONTAMINA AND GIVES B-10 TO 20000 HOURS NORMALLY.

7. REMARK FOR PURCHASE ORDER

. GENERATOR CAN BE MADE FOR12 LEADS (IF NEED, PLEASE INDICATE THE REQUIREMENT IN THE PURCHASE ORDER), WHICH CAN BE USED FOR THE FOLLOWING CONDITIONS:

50HZ : 190~280V/380~460V

60HZ:280-240V/416-480V

8. RUNNING IN PARALLELING

• MP SERIES GENERATORS COULD RUN IN PARALLELING, AND EACH ROTOR BE ASSEMBLED WITH FULL DAMPING WINDING TO PROVIDE STABLE RUNNING.
• IN PARALLELING RUNNING, THE ACTIVE LOADING IS DISTRIBUTED BY ENGINE GOVERNOR, ANDTHE REACTIVE LOADING IS DISTRIBUTED BY GENERATOR VOLTAGE REGULATOR.
• GENERATORS WITH SE350& PM300 RUNNING IN PARALLELING SHOULD ASSEMBLE PARALLELING MODULE (AMP2000) AND CT (5VA). IT IS TO INSURE THE BALANCE OF REACTIVE LOADING DISTRIBUTION BY VOLTAGE DROOP OR REACTIVE DIFFERENTIAL COMPENSATION.
• GENERATORS WITH PMG & DVR2000E COULD ONLY ASSEMBLE CT (5VA) TO SUPPLY DROOP SIGNAL, BECAUSE OF THE DVR 2000E INCLUDING PARALLELING RUNNING FUNCTION.

4-Pole

Three Phase

200Y or400Y Volts

(12 Leads)

230 or115 Volts Delta

(12 Leads)

1500 RPM

NEMA Class H Insulation 40P Ambient

0. 8 Power Factor Lagging Shunt (Non-PMG)Excitation SE350 orBE350AVR